If you work in the woods, on a farm, or in the country, chances are good that you’ve worn down the rubber sole. You can rebuild your boot sole with Aquaseal SR Shoe Repair Adhesive. 

To rebuild the soles of your shoes you’ll need the following materials:

  • Aquaseal SR  
  • Masking or painter’s tape
  • Rock salt (for traction)

How to rebuild the sole of your shoes or boots:

1. Thoroughly clean the boot with a gentle cleaner such as Revivex Boot and Shoe Cleaner and a scrub brush.  Use rubbing alcohol after the cleaner to ensure the area is extra clean.

2. Create a tape barrier around the area that you will be repairing. Pay close attention to the area where you will be building up the heel, and make sure it goes high enough to support the Aquaseal SR.

3. Apply the Aquaseal SR to the area you want to build up. We had to fill a few holes in the heel, so we used the brush to push the glue into the holes.

4. Once you’ve applied enough glue to level the sole, sprinkle some rock salt on it. The rock salt creates grooves and pockets that aid in traction when dry.

5. Set the boot in a flat area to dry. After 30-45 minutes (when the glue is set and slightly tacky), remove the tape barrier so that you don’t glue the tape to your boots.

6. Boot will be completely dry after 24 hours and ready to wear. You can pick out the rock salt, or just let it wear off naturally.

TIP: To restore shine and richness to the leather after you’ve washed it, apply a waterproofing conditioner like Revivex Leather Water Repellent.

This repair technique applies to all footwear, not just Romeos. Got a pair of cowboy boots with a worn heel, or a pair of sandals with a floppy sole? Go ahead and use Aquaseal SR on those too! Go crazy. 

Products from this article

Aquaseal SR | Shoe Repair Adhesive
New Name

Aquaseal SR | Shoe Repair Adhesive

Adhesives $7.75
Revivex Boot and Shoe Cleaner

Revivex Boot and Shoe Cleaner

Cleaners $8
Revivex Leather Water Repellent

Revivex Leather Water Repellent

Protectants $8.95

Comments